kart head bench

Discussion on general flowbench design
Post Reply
robertq
Posts: 1
Joined: Sat Apr 18, 2015 11:14 pm

kart head bench

Post by robertq »

Hi guy's new member here . name is bobby, I have been reading the site few days . its way over my head . lol I need a small bench like sf60 to flow small kart heads . can pts bench be built scaled down to smaller bench . or do you have to build it to exact prints for it to work proper .
Malvin
Posts: 451
Joined: Sat Feb 27, 2010 12:50 am
Location: Pennsylvania

Re: kart head bench

Post by Malvin »

Hi and welcome to the PTS Flow Bench Forum

To answer your Question yes you can just build the plenum side of the PTS flow bench
John Holm did it he used 2 shop vacuums. I did try to find his post on it but could not
so I am sure others members here can find it and post the link to it :)
Malvin
Posts: 451
Joined: Sat Feb 27, 2010 12:50 am
Location: Pennsylvania

Re: kart head bench

Post by Malvin »

robertq

I found the link to what John Holm built just the chamber side of the PTS flow bench you can build a
separate vacuum motor box & plumb in to the lower chamber :D

http://www.flowbenchtech.com/forum/view ... f=3&t=1109
Post Reply