Orifice plates

Discussion on general flowbench design
Post Reply
varnish
Posts: 10
Joined: Sun Apr 25, 2010 9:27 am

Orifice plates

Post by varnish »

Does anyone know if the bolting holes on the PTS orifice plates are the same spacing as the big blue calibration plate/bolting holes for bore adaptor?
Brucepts
Site Admin
Posts: 1851
Joined: Fri Jan 08, 2010 3:35 pm
Location: Pennsylvania
Contact:

Re: Orifice plates

Post by Brucepts »

Yes, they are a 5" square pattern which would be a "standard" flowbench pattern.

The hole diameter is 1/4" and can be enlarged by the end user if need be.
Bruce

Who . . . me? I stayed at a Holiday in Express . . .
Post Reply