Average flow loss

Discussion on general flowbench design
RACEPUMPER
Posts: 447
Joined: Wed Aug 25, 2010 7:54 am
Location: Riverina Australia

Re: Average flow loss

Post by RACEPUMPER »

Another consideration to think about Ron, If you use 12 of the LH2093-240, your total flow in a bench with a 16" rise would be only be 100-120 cfm @ 100".

Jim
I really love making stuff but don't finish much
ronm
Posts: 78
Joined: Fri Aug 26, 2016 7:08 pm

Re: Average flow loss

Post by ronm »

My posts don't always work. I will probably never test over 44" but I will be using some steel bracing in certain locations. Working on the slider assembly and motor mounts and motor plate.
Post Reply