Page 1 of 1

Pass-Around-Plates (PAP's)

Posted: Sat Nov 06, 2010 8:00 pm
by Brucepts
I've had a few questions about the PAP's I sell and what are they?

This was a set of plates that was sent around the USA for testing on various flowbenches, it was a "blind test" and nobody knew what the plates were suppose to flow as calculated. It took a few months for the plates to make it around and was interesting seeing the results.

I have attached a link to the discussion on these plates from the old forum. RESULTS:http://www.tractorsport.com/cgi-bin/for ... ;f=1;t=230

By using a set of these plates one can compare their flowbench to someone else's flowbench and get a good idea of it's accuracy.

Re: Pass-Around-Plates (PAP's)

Posted: Sat Nov 20, 2010 9:37 pm
by Brucepts
So that everyone does not have to wade through the old post to find the spreadsheet of results