|PTS Flowbench Forum
|Page 1 of 1|
|Author:||Brucepts [ Sat Nov 06, 2010 8:00 pm ]|
|Post subject:||Pass-Around-Plates (PAP's)|
I've had a few questions about the PAP's I sell and what are they?
This was a set of plates that was sent around the USA for testing on various flowbenches, it was a "blind test" and nobody knew what the plates were suppose to flow as calculated. It took a few months for the plates to make it around and was interesting seeing the results.
I have attached a link to the discussion on these plates from the old forum. RESULTS:http://www.tractorsport.com/cgi-bin/forum/cgi-bin/ikonboard.cgi?s=6e53317efd1d39867bd8e26f17d37c2d;act=ST;f=1;t=230
By using a set of these plates one can compare their flowbench to someone else's flowbench and get a good idea of it's accuracy.
|Author:||Brucepts [ Sat Nov 20, 2010 9:37 pm ]|
|Post subject:||Re: Pass-Around-Plates (PAP's)|
So that everyone does not have to wade through the old post to find the spreadsheet of results
|Page 1 of 1||All times are UTC - 5 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group