Page 4 of 4

Re: Computer Flow BenchControl and Data Logging

Posted: Tue Feb 07, 2012 5:32 am
by johnsmith
Hi Guys,

Sticking with the data logging theme - I have been looking at picolog:

http://www.picotech.com/multi-channel-daq.html

as the basis of an engine dyno data acquisition setup.

Now, I know next to nothing about data logging so right at the bottom of the learning curve.

I have also heard Aduino mentioned several times - any thoughts on either of these routes for either flow bench or dyno?

I started a seperate thread in General Dyno Discussion about data for that application.

Cheers.

Re: Computer Flow BenchControl and Data Logging

Posted: Tue Feb 07, 2012 4:31 pm
by Tony
That picolog would certainly work as a flow bench data acquisition system, but for a dyno you really need at least one high speed digital input for measuring speed/rpm.

Re: Computer Flow BenchControl and Data Logging

Posted: Mon Feb 27, 2012 4:26 pm
by Rub87
Why not use a Bosch MAF? they come in all sizes, are available with analog (0-5v) or digital (frequency) output.

http://rb-aa.bosch.com/boaasocs/index.j ... cat_id=132

If you want to overcome the DAC 10 bit resolution you can use the digital in, providing youhave enough sample rate, IIRC they go till about 6-8kHz or so.. and good thing is if you use a standard one, you find voltage to flow curve directly online.. if you use one from a car, it's not too hard most of the times to extract the curve from the cars ecu (software), this is usually a curve with 16 or 32 breakpoints