It is currently Sun Feb 18, 2018 6:12 pm

Reply to topic  [ 3 posts ] 
 Locating a leak 
Author Message

Joined: Fri Apr 30, 2010 5:09 am
Posts: 2
What is the best way to test your bench for a leak.I heard a pop noise when i was flowing an exhaust port and cannot seems to get the pressure i was getting before.I do not see anything that stands out.
Thanks in advance

Tue May 08, 2012 7:55 am

Joined: Sat Mar 03, 2012 9:45 pm
Posts: 27
put it in exhaust mode with a few inches (10 or so should do) of positive pressure and spray some soapy water on all the seams, seals and fittings. i had some elusive leaks and tried using the velocity probe but the old soapy water trick is what finally did it.

Wed May 09, 2012 3:01 am

Joined: Wed Mar 03, 2010 3:40 pm
Posts: 1285
Location: Melbourne, Australia
Yup, a bucket full of soap suds, and scoop up big hand fulls of bubbles will locate even a pin hole leak.

Also known as the infamous "Warpspeed" on some other Forums.

Wed May 09, 2012 6:01 pm
Display posts from previous:  Sort by  
Reply to topic   [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software for PTF