Page 1 of 1

FP1 setup with FP2.0 tube

Posted: Tue May 15, 2012 5:06 pm
by vic_dahn
Could anyone help me with some commands to get a base configuration on this setup?

I will be testing around 28 but i would still like my CFM to be calculated to 28

I am currently using a FP2.0 with water manometers and it is very close every time I calibrate. I have even checked it with 10 calibrated orifice plates and it was a percent or 2 good enough for me :)

I would like to go digital but this box is like going back to stone age of PC programming, and its support docs are ....... well ....... :twisted:

Re: FP1 setup with FP2.0 tube

Posted: Tue May 15, 2012 10:30 pm
by vic_dahn
got it!