It is currently Sun Feb 25, 2018 7:10 am



Reply to topic  [ 11 posts ]  Go to page Previous  1, 2
 adjustable orifice 
Author Message

Joined: Wed Oct 30, 2013 8:10 pm
Posts: 93
Hi,

I have also tested the sliding plate system. When calibrated, the flow numbers are within 0.3 cfms from a range of 25 to 250. Tested with about 20 objects and five positions.
I had two plates with a round slot cut to 44.5 mm sliding against each other in a groove.
The plate was adjusted with a screw with position markers. Unfortunatly this could not be implemented without leaks in my orifice in pipe design.
/kimi


Mon Feb 06, 2017 4:44 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 11 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software for PTF