Computer Flow BenchControl and Data Logging

Anything that does not fit into pitot or conventional orifice flowbench design
johnsmith
Posts: 27
Joined: Thu Feb 10, 2011 2:14 am

Re: Computer Flow BenchControl and Data Logging

Post by johnsmith »

Hi Guys,

Sticking with the data logging theme - I have been looking at picolog:

http://www.picotech.com/multi-channel-daq.html

as the basis of an engine dyno data acquisition setup.

Now, I know next to nothing about data logging so right at the bottom of the learning curve.

I have also heard Aduino mentioned several times - any thoughts on either of these routes for either flow bench or dyno?

I started a seperate thread in General Dyno Discussion about data for that application.

Cheers.
Tony
Posts: 1438
Joined: Wed Mar 03, 2010 3:40 pm
Location: Melbourne, Australia

Re: Computer Flow BenchControl and Data Logging

Post by Tony »

That picolog would certainly work as a flow bench data acquisition system, but for a dyno you really need at least one high speed digital input for measuring speed/rpm.
Also known as the infamous "Warpspeed" on some other Forums.
Rub87
Posts: 5
Joined: Tue Feb 21, 2012 12:03 pm
Location: Belgium

Re: Computer Flow BenchControl and Data Logging

Post by Rub87 »

Why not use a Bosch MAF? they come in all sizes, are available with analog (0-5v) or digital (frequency) output.

http://rb-aa.bosch.com/boaasocs/index.j ... cat_id=132

If you want to overcome the DAC 10 bit resolution you can use the digital in, providing youhave enough sample rate, IIRC they go till about 6-8kHz or so.. and good thing is if you use a standard one, you find voltage to flow curve directly online.. if you use one from a car, it's not too hard most of the times to extract the curve from the cars ecu (software), this is usually a curve with 16 or 32 breakpoints
Post Reply