3D printed hose "T" joiners
Posted: Wed Jan 05, 2022 7:17 pm
I'm combining the DM box and the Motor controller Box into the one larger box that I can attach to the flowbench when I build it. I'm taking the circuit boards and associated pieces out of the the two boxes and putting them into the one larger box so everything is together.
Because the Motor controller AND the DM use the same depression signal they are joined together. I need to splice into the line between the pressure transducer and the bulkhead fitting on the box. Unfortunately I can't find any fittings small enough and can't even find the tube that Bruce uses in Australia. So, if I splice in at the little tube I can use the bulkhead fittings from the Motor Controller and just put them in the box.
What I ended up doing was modelling the "T" fittings I needed and printing them on the resin printer. Man I love this new printer!!!
Because the Motor controller AND the DM use the same depression signal they are joined together. I need to splice into the line between the pressure transducer and the bulkhead fitting on the box. Unfortunately I can't find any fittings small enough and can't even find the tube that Bruce uses in Australia. So, if I splice in at the little tube I can use the bulkhead fittings from the Motor Controller and just put them in the box.
What I ended up doing was modelling the "T" fittings I needed and printing them on the resin printer. Man I love this new printer!!!