Page 1 of 1
Signed up for the new forum
Posted: Fri Apr 30, 2010 12:32 pm
by Tom Vaught
Anyone still using the old forum except for reference?
Tom Vaught
Re: Signed up for the new forum
Posted: Fri Apr 30, 2010 1:50 pm
by Brucepts
What took you so long??? LOL
The old forum is going to become reference/read-only as soon as I figureout how best to do it.
Prefer to have any new posts/replies started here.
Re: Signed up for the new forum
Posted: Fri Apr 30, 2010 1:54 pm
by Flash
Thought it was set to read only............when over there and noticed there was a couple posts.
Re: Signed up for the new forum
Posted: Fri Apr 30, 2010 1:59 pm
by Flash
Brucepts wrote:What took you so long??? LOL
The old forum is going to become reference/read-only as soon as I figureout how best to do it.
Prefer to have any new posts/replies started here.
Maybe when you change it to read only, you can add a message to whom ever trys to post up, This address and an explanation of how to get here and re sign up.
Re: Signed up for the new forum
Posted: Wed Jul 21, 2010 11:26 pm
by S.Brown
Tom Vaught wrote:Anyone still using the old forum except for reference?
Tom Vaught
This wouldn't happen to be the Tom Vaught from Westland Michigan, would it?
I believe it was Oakwood Lane, back in the day?
Re: Signed up for the new forum
Posted: Sat Sep 11, 2010 6:08 pm
by putlove
Im new to this forum today. I was reading about the orfice plate that was sent to other flowbench owners. Could i buy a set of those plates to check my machine? I have a 17 inch stainless disc turn around in my machine im building right now. I had merriam instruments help me with calibration. They sent me a full print out for all the flow ranges i wanted. I would really like to compare my numbers with you guys when its running. Thanks,jim
Re: Signed up for the new forum
Posted: Sun Sep 12, 2010 10:45 am
by Brucepts
putlove wrote:Im new to this forum today. I was reading about the orfice plate that was sent to other flowbench owners. Could i buy a set of those plates to check my machine? I have a 17 inch stainless disc turn around in my machine im building right now. I had merriam instruments help me with calibration. They sent me a full print out for all the flow ranges i wanted. I would really like to compare my numbers with you guys when its running. Thanks,jim
Welcome to the forum! You can find parts here:
http://www.flowbenchtech.com/flowbenchparts.html