PTS Flowbench Forum

I'm not sure if anyone is still tossing up ideas on bench design, but I for one can recommend the pts plans.
My flowbench is now working, calibrated and pulling some big numbers.
This 3 phase 12 motor bench pulls 838 cfm @ 28" and can run at 85".
It is a pts design with material and structural changes to cope with high depression.
This is the fourth bench I have constructed and by far the most accurate and consistant.

Thanks Bruce and Tony for all your help along the way.

Which motors are you using.

RACEPUMPER wrote:I'm not sure if anyone is still tossing up ideas on bench design, but I for one can recommend the pts plans.
My flowbench is now working, calibrated and pulling some big numbers.
This 3 phase 12 motor bench pulls 838 cfm @ 28" and can run at 85".
It is a pts design with material and structural changes to cope with high depression.
This is the fourth bench I have constructed and by far the most accurate and consistant.

Thanks Bruce and Tony for all your help along the way.

It is an impressive bench. Nice work!

12 ameteks Old Grey, 9 x 119996 and 3 x 119998.
And thanks Larry.

Jim

Post photo of your beast!